13
0x0C(12)
Enable/Disable the PIR
0 = Disable the PIR.
1 = Enable the PIR.
0x0D (13)
Setup the wait time of PIR for clear the motion.
Valid values: 0x05~0x3BC4
0x0E (14)
When the Motion Sensor is triggered, if this parameter is
0x01 then it will send Basic set command to group 1.
0 = Don't send.
1 = Send.
0x0F (15)
PIR triggers the correspondence between the value of
the Basic set and the PIR state.
-If this value is 0x00 :
PIR triggers send the basic set with 0xFF, PIR alarm
release send the basic set with 0x00.
-If this value is 0x01 :
PIR triggers send the basic set with 0x00, PIR alarm
release send the basic set with 0xFF.
Only support 0x00 and 0x01 values as valid value.
0x10 (16)
Motion detection sensitivity level is a value between 1
and 10. This value affects the amount of motion energy
required to generate a motion event and also affects the
detection range and angle.
1 = Lowest Motion Sensitivity
10 = Highest Motion Sensitivity
0x11 (17)
Enable/disable pet immunity mode. This feature is lens
dependent and detection range may be reduced
when Pet Immunity is enabled.
0 = Disable the
pet immunity mode
1 = Enable the
pet immunity mode
0x12 (18)
Configure lightsensor to upload data form
1=Upload lumens value.
2=Upload day or night(By notification).
3=Upload lumens and day/night .
5.5
Sensor_Multilevel
Command
value
Sensor multilevel supported
Air temperature (bit 0),
Luminance (bit 2).
