Leedarson 7A-SS-VE-H0, Быстрый старт

Страница: 5 / 11

5
7. Product Usage
7.1 How to add (include) the Door/Window Sensor to a Controller/Gateway
Door/Window Sensor Inclusion Procedure:
Make sure the sensor is powered.
1. Set the Z-Wave network main controller into learning mode.
2. Short press the button one time. (within 1 second)
3. If the inclusion is successful, the LED will blink for less than 5 seconds and then stay on for 3 seconds.
Otherwise, the LED will blink 8 seconds and then turn off, in which case, you will need to repeat the
process from step 2.
7.2 How to exclude a Door/Window Sensor from Controller/Gateway
Door/Window Sensor Exclusion Procedure:
1. Make sure the sensor is powered.
2. Set the Z-Wave network main controller into learning mode.
3. Short press the button one time. (within 1 second)
4. If the exclusion is successful, the LED will blink 3 times. Otherwise, the LED will blink for 3 seconds
and then turn off, in which case, you will need to repeat the process from step 2.
7.3 How to reset a Door / Window Sensor
Reset procedure deletes memory, including all information on the Z-Wave network and the hub.
Contact Sensor’s Reset Procedure:
1. Make sure the sensor is powered.
2. Press and hold the button for 5 seconds.
3. Release the button.
4. Door/Window Sensor will send “Device_Reset_Locally” to the main controller and exclude it from the
Z-Wave network and reset the sensor to the factory default.
Caution:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.