v.8.29.19
Ledra Brands Inc.
www.LedraBrands.com
In a continuing effort to offer the best product possible we reserve the right to change, without notice, specifications or materials that in our opinion will not alter the function of the product.
15774 Gateway Circle Tustin, CA 92780
P 714.259.9959 F 714.259.9969
7
2. INSPECT THE CUTTER ASSEMBLY
The cutters may or may not be installed
and ready for use in your Drill Jig. Inspect
inside the cutter assembly and follow the
appropiate steps to confirm your setup:
2.1 Ensure that the cutter end is fully
retracted inside the cutter assembly.
If not, reverse the cutter into the assembly
by engaging the drill (reverse) on the Drill
Jig hex drive (Fig 2.1) The cutters should
NOT protrude from the cutter assembly.
2.2 If cutters are not yet installed (Fig. 2.2),
proceed to install them as shown in step 3.
NOTE! Check if a flat face spacer is
present inside the cutter assembly.
ONLY use the spacer if drilling
square/flat-face pipe. Refer to
ZETA 750 SNAP Drill Jig Flat
Face Setup.
CUTTERS ARE INSTALLED
CUTTERS ARE NOT INSTALLED
flat face spacer
Above: The flat face spacer is
used with square pipe ONLY
Fig. 2.1 If cutters are pre-installed, use your
drill to ensure that both the hex drive and cutter
end of the cutter assembly are fully retracted.
Fig. 2.2 Cutter end of the cutter assembly
pictured above. The cutters are not yet installed.
Proceed to cutter installation (step 3).
CORRECT. Cutters are installed and fully
retracted inside the cutter assembly.
INCORRECT. Installed cutters should NOT
remain protruding from the cutter assembly.
Ensure that cutters are fully retracted inside
the cutter assembly before using the Drill Jig.
mark LED positions
with tape
LED spacing
Fig 1.1. Measure and mark the LED Puck positions on the rail.
1
2
mark LED positions
with tape
LED spacing
Fig 1.1. Measure and mark the LED Puck positions on the rail.
1
2
mark LED positions
with tape
LED spacing
Fig 1.1. Measure and mark the LED Puck positions on the rail.
1
2
mark LED positions
with tape
LED spacing
Fig 1.1. Measure and mark the LED Puck positions on the rail.
1
2
mark LED positions
with tape
LED spacing
Fig 1.1. Measure and mark the LED Puck positions on the rail.
1
2
