v.8.29.19
Ledra Brands Inc.
www.LedraBrands.com
In a continuing effort to offer the best product possible we reserve the right to change, without notice, specifications or materials that in our opinion will not alter the function of the product.
15774 Gateway Circle Tustin, CA 92780
P 714.259.9959 F 714.259.9969
5
HOW THE DRILL JIG WORKS
WHAT IS THE ZETA 750 SNAP DRILL JIG
MINIMUM WALL THICKNESS
COUNTERBORING
THE DRILL JIG IN USE
The ZETA 750 SNAP Drill Jig’s purpose is to
enable consistent and accurate drilling of metal
pipe, with counterbore, and to significantly
reduce installation time.
The ZETA 750 SNAP Drill Jig is designed for
the following:
- Use with a battery-operated (cordless)
drill ONLY
- Installing the latest generation LED
Puck Snap-type modules ONLY: Snap,
Solo, Zero, RGBW, Wide and IP68
Use with curved-face metal rail, or flat-
faced rail (spacer fitting required for flat
faced-rail, see note*)
Cutting a hole with a 15mm diameter
and a 16mm counterbore. See Minimum
Wall Thickness table.
Observe the Drill Jig / LED Puck
requirements for minimum wall thickness.
To ensure counterboring works as
intended, make sure that your 15mm and
16mm cutter installation is correct (step
3). The result should be the LED Puck
embedded flush within the rail (below).
Table 1. Minimum wall thickness for different rail types.
Contact LEDRAbrands or your distributor if your specifications
are outside these minimums. *See Flat Face note below.
Above: The ZETA 750 SNAP Drill Jig in use. Proper use of the
Drill Jig will result in a significantly faster and more professional
finish.
TIP! Test your first hole on a spare piece
of pipe and spare LED Puck.
*NOTE! Square pipe / flat-faced rail
applications require a spacer fitted to
the Drill Jig. Refer to the supplementary
document: ZETA 750 SNAP Drill Jig Flat
Face Setup (page 16).
Operating a drill attached to the ZETA 750
SNAP Drill Jig will automatically drive its
cutters into the cutting surface until full depth
is achieved and the hole fully made. The Drill
Jig will automatically cut the counterbore
hole. Once cutting is achieved, reversing
the drill will withdraw the cutters back
nside the Drill Jig cutter assembly and
into a position ready for the next hole.
RAIL TYPE
MINIMUM
THICKNESS
CURVED FACE (TUBE)
1.5mm
CURVED FACE (TUBE)
2.0mm
Curved Face (Tube) Rail
Flat Face (Square) Rail
*See flat face rail note
(right)
