v.8.29.19
Ledra Brands Inc.
www.LedraBrands.com
In a continuing effort to offer the best product possible we reserve the right to change, without notice, specifications or materials that in our opinion will not alter the function of the product.
15774 Gateway Circle Tustin, CA 92780
P 714.259.9959 F 714.259.9969
12
7. CHECK YOUR DRILL SETUP
The Drill Jig is designed to be used with a
battery-operated (cordless) drill ONLY.
Above: our example drill is set to “Drill”; high
torque; and LOW speed (1)
Above: Check the 10mm driver bit is secure
NOTE! REMINDER! Confirm you have
applied lubrication to Drill Jig cutter
(step 5).
NOTE! Drill should be set to the LOW
speed setting. A MAXIMUM 400 RPM
drill is recommended. Higher speeds
will reduce cutter life and increase the
chance of work hardening.
BEFORE YOU DRILL:
7.1 Check that the 10mm driver bit is
secure in the drill and that the chuck is tight.
7.2 Check that your drill is set to
- LOW / SLOW speed / RPM
-the “DRILL” setting
-clockwise direction
-the highest torque setting
7.3 Put on your eye protection and any
other appropiate PPE.
READ AND OBSERVE THE SAFETY PRECAUTIONS AND
OPERATING INSTRUCTIONS ON YOUR CHOSEN DRILL AND
EQUIPMENT.
DRILL JIG MUST BE USED WITH A BATTERY -POWERED
(CORDLESS) DRILL ONLY. DO OT USE A MAINS POWERED
DRILL.
DO NOT USE A ROTARY/IMPACT/HAMMER DRILL OR SUCH
SETTINGS ON YOUR DRILL. DRILL MUST BE SET TO DRILL
SETTING AND A LOW DRILL SPEED (MAXIMUM OF 400RPM).
set drill to clockwise
set SLOW / LOW
speed (RPM)
set to "DRILL" setting or lowest
RPM setting
set drill to highest torque setting
(if applicable )
set drill to clockwise
set SLOW / LOW
speed (RPM)
set to "DRILL" setting or lowest
RPM setting
set drill to highest torque setting
(if applicable )
