v.8.29.19
Ledra Brands Inc.
www.LedraBrands.com
In a continuing effort to offer the best product possible we reserve the right to change, without notice, specifications or materials that in our opinion will not alter the function of the product.
15774 Gateway Circle Tustin, CA 92780
P 714.259.9959 F 714.259.9969
15
TROUBLESHOOTING GUIDE
ISSUE: Thr drill spins when reversing/the Drill Jig
hex drive does not retract when reversing and
appears stuck.
SOLUTION: The hex drive is not
disengaging from the cutters. To resolve,
offset the angle of the drill slightly (1-2º)
while reversing. The hex drive should now
disengaging and retract.
ISSUE: The cutters do not cut/takes
a long time to cut.
SOLUTION:
1. Confirm a slug is not present/stuck
inside the cutter assembly.
2. The cutters may be blunt. Refer to
Install/Replace the Cutters (step 3).
ISSUE: Shaving coloring appears unusual.
SOLUTION:
1. The Drill speed (RPM) is too high.
Lower the drill speed.
2. There is not enough lubrication on the
cutters. Lubricate the cutters (step 5)
3. The cutters are blunt/damaged.
Replace the cutters (step 3).
NOTE! If you have an issue that is not
identified/resolved here, please contact
your supplier or Ledra Brands for support
Do NOT attempt to modify the Drill Jig or
operate it outside of the range described
within this manual. If the Drill Jig is not
functioning as expected please contact
Ledra Brands ASAP at (714) 259-9959.
DO NOT ATTEMPT TO MODIFY THE DRILL JIG OR OPERATE IT
OUTSIDE OF THE RANGE DESCRIBED WITHIN THIS MANUAL.
CONTACT LEDRABRANDS ASAP IF THE DRILL JIG IS NOT
OPERATING AS EXPECTED.
