Ledco HD-25, Инструкция по эксплуатации

Страница: 23 / 52

5. With both rolls threaded and installed in their respective brackets, unwind
the top and bottom supply rolls about a half-turn each. This will provide
enough slack in the web to allow the feed tray to slide on easily.
6. Slide the feed tray into position. Position the safety shield forward toward
the heat shoe. Remember the drive will NOT engage without the feed table
and the safety shield in their proper positions.
7. Make sure there is still enough slack in the web. Close the laminating
rollers with the two large knobs on the right side of the unit. With the film
draped over the two heat shoes, and melted or taped together, push one
edge of the threading card between the heat shoes so that the film is firmly
positioned against the laminating rollers. Make sure the rubber rollers are in
the closed position. If a threading card is not available any piece of card
stock or poster board will work.
8. Push the forward drive switch. If the film and the card are in the nip (the
point where the laminating rollers meet), the film and the threading card will
start into the laminator and will pass through both sets of rubber rollers.
When the threading card has cleared the back of the machine press the
STOP switch.
22