Leadvision Pool Fence, Руководство по установке

Страница: 8 / 13

8
NOTE: Stabilize drill guide with foot pressure to prevent drill guide form shifting. *Sleeving: Once drilling is
complete flush out the debris from the holes using a garden hose Fig.19 . Next insert the plastic sleeves in the
holes and tap down completely Fig.20 .
Installing Sections:
Start at a double hole (where sections connect)and put you first pole in. You should
always lean the pole you are leading with back as shown below in
Fig.20
to get it started in the hole. Then
push the pole forward along the line of fence and down into the hole until the bottom of the fence is flush
with the deck sleeve. Repeat this until all your sections are installed.
NOTE: Stabilize drill guide with foot pressure to prevent drill guide form shifting.
* Sleeving: Once drilling is complete flush out the debris from the holes using a
garden hose Fig.19 . Next insert the plastic sleeves in the holes and tap down
completely Fig.20 .
* Installing Sections: Start at a double hole(where sections connect)and put you first
pole in. You should always lean the pole you are leading with back as shown below
in Fig.20 to get it started in the hole. Then push the pole forward along the line of
fence and down into the hole until the bottom of the fence is flush with the deck
sleeve. Repeat this until all your sections are installed.
Step 4: Making Your Custom Cut
*Measuring Your Custom Cut: Your custom section Is the one that doesn’t fit. The
first step is to measure your custom cut. Note whether you will be cutting from the
right side or the left side of the full section. See Fig.21 below
NOTE: Stabilize drill guide with foot pressure to prevent drill guide form shifting.
*
Sleeving:
Once drilling is complete flush out the debris from the holes using a
garden hose Fig.19 . Next insert the plastic sleeves in the holes and tap down
completely Fig.20 .
* Installing Sections: Start at a double hole(where sections connect)and put you first
pole in. You should always lean the pole you are leading with back as shown below
in Fig.20 to get it started in the hole. Then push the pole forward along the line of
fence and down into the hole until the bottom of the fence is flush with the deck
sleeve. Repeat this until all your sections are installed.
Step 4: Making Your Custom Cut
*Measuring Your Custom Cut: Your custom section Is the one that doesn’t fit. The
first step is to measure your custom cut. Note whether you will be cutting from the
right side or the left side of the full section. See
Fig.21
below
Fig. 19
Fig. 20
PRO NOTE:
To keep from damaging the sleeve, place
a wood block on top of it as shown and
gently tap sleeve down into the hole
until it
is flush with the ground.
Fig. 20
Screws face away from the pool