Leadvision Pool Fence, Руководство по установке

Страница: 4 / 13

4
*Now repeat until pole 5th of the section Fig. 6-7a
*Mark your last hole for that section, (hole 5) Fig. 7a.
*Then use the double hole on the template and align it over the 5th hole your marked Fig. 7b and mark the
first hole of the next connecting section to the right,(hole). Repeat these steps on the both sides of the pool
until you reach the section that will be the cut section.
*Custom Cut: Is when the last piece is less than the 36’’ template, Marking your custom cut is just like mark-
ing out a full 36” panel is usually shorter than 36”. This is the custom cut you will make later. This section is
the last one marked out, usually in the back of the pool, when you will not notice it. The last piece will most
likely have fewer poles in it. This example depicts a two pole cut.
*Now repeat until pole 5 th of the section Fig.6-7a
*Mark your last hole for that section, (hole 5)
Fig.7a
.
*Then use the double hole on the template and align it over the 5 th hole your marked
Fig.7b and mark the first hole of the next connecting section to the right,(hole).
Repeat these steps on the both sides of the pool until you reach the section that will
be the cut section.
*Custom Cut: Is when the last piece is less than the 36’’template, Marking your
custom cut is just like marking out a full 3 foot panel is usually shorter than 3 feet.
This is the custom cut you will make later. This section is the last one marked out,
usually in the back of the pool, when you will not notice it. The last piece will most
likely have fewer poles in it. This example depicts a two pole cut.
*Now repeat until pole 5 th of the section Fig.6-7a
*Mark your last hole for that section, (hole 5) Fig.7a .
*Then use the double hole on the template and align it over the 5 th hole your marked
Fig.7b and mark the first hole of the next connecting section to the right,(hole).
Repeat these steps on the both sides of the pool until you reach the section that will
be the cut section.
*Custom Cut: Is when the last piece is less than the 36’’template, Marking your
custom cut is just like marking out a full 3 foot panel is usually shorter than 3 feet.
This is the custom cut you will make later. This section is the last one marked out,
usually in the back of the pool, when you will not notice it. The last piece will most
likely have fewer poles in it. This example depicts a two pole cut.
*Now repeat until pole 5 th of the section
Fig.6-7a
*Mark your last hole for that section, (hole 5) Fig.7a .
*Then use the double hole on the template and align it over the 5 th hole your marked
Fig.7b and mark the first hole of the next connecting section to the right,(hole).
Repeat these steps on the both sides of the pool until you reach the section that will
be the cut section.
*Custom Cut: Is when the last piece is less than the 36’’template, Marking your
custom cut is just like marking out a full 3 foot panel is usually shorter than 3 feet.
This is the custom cut you will make later. This section is the last one marked out,
usually in the back of the pool, when you will not notice it. The last piece will most
likely have fewer poles in it. This example depicts a two pole cut.
Fig. 8
Placed Over
Previous Hole
Placed Over
Previous Hole
All full sections have 5 poles attached to
the mesh. When marking-out make sure
you always count your holes before mark-
ing-out your next section. Also count your
holes again before you drill to makes sure
you didn’t mark too many or too few holes