31
CPU Vcore Select [Default]
For setting the Vcore voltage. The options include: 1.100V -> +2.000V
AGP Slot Vddq Select [Default]
The options are:
+0.2 V
,
+0.1 V
,
and Default
.
4.10. Load Basic Defaults
The BASIC Defaults have been set to provide the minimum requirements for your
system to operate. Its performance is lower than the “Load Best Defaults”. We
suggest you use “Load Best Default”. If your system card has compatibility issues,
use the “Load Basic Defaults”.
4.11. Load Best Defaults
The “Load Best Defaults” function loads the system manufacture default data. This
is the default setting from Leadtek. This function will be necessary when the system
CMOS data is corrupted or you forget your settings.
4.12. Set Supervisor/User Password
Passwords can be set to provide protection for the BIOS configuration options, or
to restrict access to the computer itself.
When enabled, User Password will require all users to enter a password in order to
use the system, and/or enter the BIOS setup (but can’t change its contents). A
Supervisor Password is used to protect the stored CMOS options from being
changed by unauthorized users.
Keep in mind that when set, a password is required only when booting the system.
It will not provide protection to a system that is already booted.
The password check option is set in BIOS FEATURES SETUP by choosing either
System (the password prompt appears every time the system is powered on) or
Setup (the password prompt appears only when the user enters the BIOS Setup).
The password is stored in CMOS RAM, and can be cleared by removing the
battery for a while and then re-installing it back.
To set a password:
y
You must first set the Supervisor password by choosing Supervisor Password
and pressing [ENTER]. Setup prompts for a password.
y
Enter a 1~8 character password using letters, numbers, or a combination of
both. The specific characters are not shown as you enter them. Press
[ENTER].
y
A confirmation box appears asking you to re-enter the password. Enter the
password again. Press [ENTER]. Follow the same procedure to set the User
Password.
