7
DIMM Installation Procedures
The DIMM slot has two keys marked
“VOLT” and “DRAM”, thus making the
module only fit in one direction. Note that
the module must be a 2.5 V unbuffered
DIMM.
Step 1:
Insert the module vertically into
the DIMM socket, and then
push it in.
Step 2:
The plastic clip at the side of the DIMM socket will automatically close.
3.3. AGP Display Adapter Installation
The AGP slot on WinFast K7NCR18 series supports only 1.5 V 4x/8x AGP device.
To install an AGP display adapter, follow these steps:
Step 1:
Push the clip at the end of AGP slot.
Step 2:
Position the AGP card over the AGP slot. Do
not tilt the card. Insert the bus connector in the
slot and gently press the bus connector down.
Step 3:
Push the clip back to close it
.
Step 1
Step 2
Step 3
3.4. Connecting
Instructions
How each connector is connected and what it does is
described here in detail. See Chapter 2 to locate
connectors.
Case Signal Connectors (FP1 & FP2)
FP1:
Pins [1&3] IDE-LED:
IDE hard disk LED shows the
activity of a hard disk drive.
