Hardware Manual for the DMC5400 Motion Controller
Tel: +086 0755-26434369 Email: [email protected] Web Site: www.leadshine.com
Page: 24/36
Chapter 6 Motion5000 Demo Software
The Motion5000 Demo software, a Microsoft Windows based software is equipped with the DMC5400 card for
supporting application development. The Motion5000 Demo software is very helpful for verifying and testing a
motion control system during the design phase of a project.
You will see the default window, namely Motion Configuration Window like Figure6.1 after running the
Motion5000 demo software. The Motion5000 includes 4 main windows. They are Motion Configuration Window,
I/O Status/Control Window, Controller Configuration Window and Function Testing Window. There are four
buttons on the Main Toolbar
which can be used to switch these four windows.
Figure 6.1: Motion5000 demo software (the Motion Configuration Window, the default window)
Main Toolbar
1.
New File Button. It can be used to open a new program file, and it
’
s only active in the Function Testing
Window.
2.
Open File Button. It can be used to open an existed program file, and it
’
s only active in the Function
Testing Window.
3.
Save File Button. It can be used to save a program file, and it
’
s only active in the Function Testing
Window.
4.
Run Program Button. It can be used to run a program file, and it
’
s only active in the Function Testing
Window.
5.
Emergency Stop Button. It can be used to stop a running a program file.
