4.3.1 KEYBOARD ID
The keyboard ID selection roulette is only available in the
expansion keyboards attached to the MPS-8Z. This selection
roulette is located at the base of the device in the central part. It
allows to select the location of the keyboard within the set of all
the attached keyboards. Each keyboard should have a different
ID. In a PA/VA System where the Zone Buttons have not been
con figured (with NEO Con figurator), the zone associated to each
button will be determined by the ID selected in the roulette. The
zone assigned to each button will be by default as follows:
•
ID 1: Zones 9-16
•
ID 2: Zones 17-24
•
ID 3: Zones 25-32
•
ID 4: Zones 33-40
•
ID 5: Zones 41-48
•
ID 6: Zones 49-56
•
ID 7: Zones 57-64
•
ID 8: Zones 9-16 Selection not allowed, by default it will
assigned ID 1.
•
ID 9: Zones 9-16 Selection not allowed, by default it will
assigned ID 1.
•
ID 0: Zones 9-16 Selection not allowed, by default it will
assigned ID 1.
4.4 MPS 8Z CONFIGURATION
It is possible to con figure MPS-8Z Paging Microphone according to several operation
parameters. To access the con figuration mode of the device, follow these steps:
•
Make sure the device does not have conceded word. The “CW” light should be off.
•
Keep pressed the button “CANCEL” and the button “EVENT” for at least 2 seconds.
•
When you are in the con figuration mode, the “FAULT” and “EMG” lights will be blinking.
•
Con figure the parameters as shown in chapter 4.4 .1 to 4.4 .6.
•
Press the button “TALK” to con firm, or “CANCEL” to cancel any change.
•
The device will restart with the new con figuration.
10
www.lda-audiotech.com
Picture 8: MPS-8K Expansion
Keyboard ID
