La-Z-Time
®
PowerRecline
TM
with Power Headrest
and Lumbar Motion Sofa, Chair & Modular
Assembly Instructions
La-Z-Time
®
PowerRecline
TM
with Power Headrest
and Lumbar Motion Sofa, Chair & Modular
Assembly Instructions
NOTICE:
Do not plug in until instructed.
Some styles (single seat styles) ship with the back unassembled, while others (multiple seat
styles) ship wth the backs assembled.
1. Remove the unit from the package, putting the back off to the side if the back is detached, and
gently roll the unit forward so that it rests on its front or top side. On units with protective pads,
cut the plastic ties and remove them from the bottom of the unit. (F
IGURE
1).
2. Gently roll the unit back to the upright position.
3. Once the furniture is unpacked, carefully remove the electrical components bag (either red, blue
or orange) from the body bracket and set aside; depending on the product purchased, inside the
bag are the power supply, power cord, optional remote, three AAA batteries for the optional
remote and for power motion sofa and loveseat units, a Y-cable. (F
IGURE
2 and 3).
•
Remove the power supply from the box and set aside (F
IGURE
3).
•
For styles with the backs assembled, proceed to step 5.
– To reduce the risk of injury:
• Do not operate the unit until the back is installed and locked.
• The back of the unit must be lifted for assembly. Please seek assistance if you are
unable to lift at least 45 pounds without strain.
WARNING
4. Install the back on styles that ship with the back unassembled.
•
Lay the back front side down on the seat, turn the outside back upholstery cover over, toward
the front of the unit, and locate the back and body brackets (F
IGURE
4).
•
Lift the back at a slight angle and align the brackets on the back with the brackets on the body.
•
Lower the back onto the body, taking care not to pinch the cables between any metal or wood
parts
and
making sure the back and body brackets are completely engaged.
Note: The back is easier to install when holding it level and lowering it evenly onto
the body brackets.
- Lift the back upholstery cover and look up into the back to visually confirm that both sets of back
and body brackets are engaged (F
IGURE
5). If one or both brackets are not engaged, or if cables are
pinched, remove the back and repeat the steps above.
- If you are unable to install the back properly, contact your La-Z-Boy
®
dealer for assistance.
•
Lock the brackets by using a screwdriver to push down the locking levers (F
IGURE
6).
F
IGURE
1
(Style X4A Featured)
F
IGURE
2
F
IGURE
3
F
IGURE
4
F
IGURE
5
F
IGURE
6
Body
Bracket
Back and Body
Brackets Engaged
Back
Bracket
Locking
Lever
Locking
Position
15
14
Back
Bracket
(PowerRecline
TM
with Power Headrest and Lumbar
Assembly Instructions Continued)
* For power motion sofas and loveseats
Power
Supply
120 Volt
Power Cord
Y-Cable
