EN–16
Accessories
Optional accessories may have been shipped with
your mower or are available from your Authorized
Lawn-Boy Dealer. For proper installation follow
these instructions.
Grass Catchers
1.
Stop the engine and disconnect the spark plug
wire (Fig. 4) before installing or removing grass
chute.
2.
Remove the wing screw that fastens the cover
plate to the housing (Fig. 5).
3.
Two shoulder bolts on housing protrude through
slotted holes in cover plate and do not have to be
loosened or removed. The cover plate moves
over shoulder bolt heads (Fig. 6).
Slide cover plate counterclockwise to remove.
4.
Place front corner of chute baffle into deck
opening. Rotate chute counterclockwise and
push down into deck opening (Fig. 33 and 34).
Note:
The chute baffle must go behind the
front deck baffle and between blade
and toe guard to prevent contact with
blade.
5.
For rear bag catchers only: Insert chute support
rod through hole in right side of deck (Fig. 35).
6.
Two shoulder bolts on the mower housing
protrude through slotted holes in the chute
assembly and do not have to be loosened or
removed. Chute assembly moves over the
shoulder bolts (Fig. 35).
7.
Slide chute assembly in a clockwise direction to
install or counterclockwise to remove.
8.
Secure with wing screw (Fig. 35).
Check clearance between blade tips and chute
baffle making sure there is no contact (Fig. 36).
Note:
The chute baffle must go behind the
front deck baffle and between blade
and toe guard to prevent contact with
blade (Fig. 36).
Rear Grass Bags Only
1.
Remove knob and bolt securing left side upper
and lower handle sections (Fig. 37).
IMPORTANT: Hold hanger clamp on outside
of handle sections. Insert handle bolt from
inside of handle sections through holes in
hanger clamp.
IMPORTANT: Position bag hanger leg into
hanger clamp groove and secure with knob.
Repeat steps and assemble clamp and hanger
to right side handle sections.
IMPORTANT: Close rear of bag by folding
sides in and pressing interlocking rear handle
halves together (Fig. 38).
IMPORTANT: Position rear bag handles into
bag hanger on handle.
IMPORTANT: Grasp bag assembly handle
and slide over flange of grass chute (Fig. 39).
Push downward on handle until it seats into
position.
When handle height is changed, bag adjustment
may be required. A properly adjusted bag should
be taut on top cloth area between front bag
handle and rear bag hanger handles. If bag is too
tight or too loose, adjust as follows:
2.
Remove bag from rear bag hanger. Remove
bolt(s) and knob(s) securing hanger clamps to
handle sections (Fig. 37). Hanger clamps have
four adjustment holes.
3.
Reassemble hanger clamps to handle sections
using whichever set of holes best holds bag taut.
Using lower holes in hanger clamps tightens bag
assembly and upper holes in hanger clamps
loosens bag assembly.
Side Grass Bags Only
1.
Remove the right side handle knob and reinstall
it on the outside of the handle (Fig. 40 and 41).
Содержание Silver Series
Страница 16: ...Figures Figuras xiv 1009 1039 1068 47 48 49...
