Pag. 34
IMPORTANT:
This manoeuvre prevents condensation from forming in the combustion chamber.
SPECI
SPECI
FIC SEQUENCE FOR BATTERY POWERED MODELS
FIC SEQUENCE FOR BATTERY POWERED MODELS
START:
1 -
Turn the key in the clockwise direction
Detail 3 Fig. 6
.
STOP:
1 -
Turn the key in the anticlockwise direction,
Detail 3 Fig. 6
.
CHAPTER 12 – CORRECT USE AND ADVICE
IMPORTANT:
Before starting the job, make sure that the surface to be swept is free of objects such as ropes,
strips of plastic or metal, rags, stick,
live electric cables
or other similar articles.
If such object are present,
remove them
to avoid damage to the machine or, in the case of live electric cables,
risks of electrocution.
Crossing over rails, small steps or guides which stick up from the floor can damage the flaps on the central brush vacuum
chamber; this being one of the most frequent causes of damage, if such object have to be crossed, lift the front part of the
machine at the moment of crossing by pressing down on the handle to gain leverage.
Avoid crossing over wet or particular damp surfaces in order to avoid damage to the paper filters. In cases of strict necessity,
before crossing stop suction pulling the lever
Detail 4 Fig. 6
.
If the area to be cleaned is very dirty owing to the quantity and quality of the dirt to be eliminated, it is advisable to pass over
the first time to get rid of the majority of the dirt, then pass over a second time with the refuse container and the suction
filters clean.
If the machine is used methodically and correctly, it is not necessary to carry out multiple passes.
To keep the machine efficient and consequently obtain top performance, the vacuum filters must be shaken and cleaned
periodically and the refuse container emptied frequently.
The side brush is used for removing dirt from edges, skirting, corners, etc. and therefore it should be kept in the raised
position when it is not carrying out this function. If it is left on the ground, it will raise dust and in this case, the cleaning
power of the central brush will be jeopardised.
For the use in small spaces or for moving round close curves, it is advisable not to use the mechanical traction so that the
machine is easier to manoeuvre.
For battery powered machines, keep a close check on the condition of the battery and recharge it as soon as the needle on the
volt meter moves onto the red zone.
NEVER LET THE BATTERIES RUN COMPLETELY FLAT AND ALWAYS LET THE BATTERY CHARGER RUN A FULL CYCLE
WHEN RECHARGING THE BATTERIES.
CHAPTER 13 – ROUTINE MAINTENANCE
_________________________________________________________________________________________
ANY MAINTENANCE OPERATION MUST BE CARRIED OUT WITH THE ENGINE OFF AND
COLD IN THE CASE OF ENDOTHERMIC VERSIONS OF THE MACHINE (GIOIA 50 ST AND
GIOIA 70 ST) AND WITH THE BATTERY DISCONNECTED IN THE ELECTRIC VERSIONS
(GIOIA 51 ET AND GIOIA 71 ET).
________________________________________________________________________________
CLEANING THE DUST FILTER:
Check the dust filter
Detail 1 Fig. 8
every 40-70 working hours or as necessary. Open the cover
Detail 1 Fig.1
to access the
filter compartment.
Cleaning the filter: with the bin
Detail A Fig.1
in place, point the compressed air gun towards the top of the filter so that the
dust falls into the bin. Make sure the filter is in good condition and replace it if necessary.
DUST SEALS
:
Содержание SW 2600 BT
