Pag. 30
SIDE BRUSH:
The side brush,
Detail 5 Fig. 4
, acts as a conveyor of the dust and rubbish and is only used to clean edges, corners and
borders; after these operations it has to be lifted up to avoid raising dust and also because the cleaning effect of the side
brush is always less than that of the main broom.
_________________________________________________________________________________________
NEVER TOUCH THE SIDE BRUSH WITH YOUR HANDS WHEN IT IS TURNING, DO NOT
COLLECT THREADY MATERIAL.
_________________________________________________________________________________________
CENTRAL BRUSH:
The main brush,
Detail 2 Fig. 5
is the main part of the sweeper. This brush collects and loads dust and rubbish in the refuse
container; it is available with different types of bristles of different harnesses according to the material to be collected; it can
be adjusted in height when it is worn.
IMPORTANT:
Never collect string, wires, packaging straps, sticks etc., that are longer than 25 cm as they could
wind around the side and main brushes.
FILTERING SYSTEM:
Thanks to the sweeper's filtering effect no dust is seen in the environment when it is working. This is achieved by means of
filters
Detail 3 Fig. 5
; the filter system can be disengaged by pulling the knob
Detail 4 Fig. 6
upwards.
IMPORTANT:
Disengage
the filter when going over damp surfaces (if the machine is running) otherwise the
paper filters will get damp causing them to deteriorate quickly.
DUST FLAPS:
See
Details 4 of Fig. 5
. These flaps are all around the main brush and are extremely important to ensure that the sweeper
works properly thanks to their suction effect; check them often to make sure they are always in a good state of repair.
REFUSE CONTAINER:
The refuse collector or container
Detail A Fig. 1
, is made in strong and resistant plastic and holds all the material collected by
the main brush and dust from the filters.
IMPORTANT:
Always empty the container after the motor has been turned off, wearing gloves and even a mask to
protect your lungs from the dust which is always present in this operation.
DESCRIPTION OF THE MANUAL COMMANDS
DESCRIPTION OF THE MANUAL COMMANDS
SWL 700 ST/ SWL 900 ST/ SW 2600 SC / SW 3700 SC:
Part. 1 - 4 - 5 - 6 – 9
SWL 700 ET/ SWL 900 ET/ SW 2600 BT/ SW 3700 BT:
Part. 1 - 2 - 3 - 4 - 6 - 7 - 8 - 9
FORWARDS LEVER:
By pulling the forwards lever,
Detail 1 Fig. 6
towards the handle, an internal mechanism is activated which causes the
moving of the sweepers at its own speed (forwards only). Traction will stop when you let go of this lever.
SIDE BRUSH ENGAGEMENT LEVER
:
The engagement lever
Detail 6 Fig. 6
makes possible to lower the brush from the driving seat. Remember that the side brush
must only be used for cleaning edges, profiles and corners and that it continues to rotate when the machine motor is working.
IMPORTANT:
Never touch the side brush with your hands and never pick up threaded materials.
DETAIL
FIG.
DESCRIPTION
1
4
Battery cover (BATTERY ONLY)
2
4
Protective case
3
4
Rh side case
3
4
Lh side case
4
4
Rh safety net
4
4
Lh safety net
5
4
Front bumper
6
4
Cover for side brush
4/A
Case switch (BATTERY ONLY)
Содержание SW 2600 BT
