Launch TLT235, Руководство пользователя

Страница: 15 / 50

Launch TLT235
、
TLT240 Economical Two-post User’s Manual
8
3 Operation Description
3.1 Precautions for vehicle repair
work
z Different vehicles have different center of gravity
positions. First understand the position of center
of gravity, and when the vehicle enters into the
lift, make its center of gravity close to the plane
formed by two columns. Adjust the swing arm,
and make the lifting pad support onto the lifting
point of the vehicle.
z
For vehicle lift with top beam ,pay attention to
the car roof position observation in order to
avoid accident during lifting.
z Carefully read the warming symbol.
z
The hydraulic valves have been adjusted before
ex-factory, and the user can’t make
self-adjustment, otherwise it will be responsible
for all the consequences generated.
z Based on the production needs, some
specifications in the instruction manual are
subjected to change without notice.
3.2 Preparation before Operation
z
Lubricate contact surface of the carriage with
general-purpose lithium grease
（
GB7324-87
）
.
All sliding surface should be coated evenly from
the top to bottom.
z
Fill hydraulic oil N32 or N46 to the oil reservoir of
the power unit.
3.3 Inspection before operation
z
Check to see if the motor power is installed properly.
z
Check to see if all the connection bolt s are fastened.
Note: Don’t operate the lift with damaged
cables or damaged and missing part, until it is
inspected and repaired by the professionals.
3.4 Lifting the Vehicle
z
Keep work area clean, don’t operate the lift in
cluttered work area.
z Lower the carriage to the lowest position.
z
Reduce the swing arm to the minimum length.
z
Swing the arm along the route of the vehicle
z
Move the vehicle to the location between the two
columns
z Swing the arm and put the lifting pad below the
recommended lifting point, and adjust the height
of lifting pad to touch lifting point of vehicle
z
Press the UP button on the electric control box,
slowly lift the vehicle to ensure the load balance,
and then raise the lift to the required height.
z
Release the UP button.
z
Press the DOWN button to engage the safety
lock of carriage. At this time, the vehicle can be
repaired.
Note:
— Before operation, the safety locking devices
must be Inspected.1) The gear blocks of the
arm end must engage the gear block of the
restraint shaft.2)No broken strand in the steel
cable. 3)No deformation in the arm pad.
— When lifting the vehicle, all the swing arms
must be used.
—
Before lifting the vehicle, check all the
hydraulic hose and fittings for oil leakage. In
case of leakage, please don’t use the lift.
Remove the fitting with leakage and re-seal.
Re-install the fitting and check if oil leakage
still exists.
— After the vehicle is lifted, when adding or
removing any major heavy object, use jack
stand to maintain the balance of the vehicle.
3.5 Lowering the Vehicle
z
Clean the work area before lowering the vehicle.
z
First press the start button to rise the vehicle a little,
then pull two steel ropes on two carriages to
disengage the safety lock.
z
Press the lowering handle to lower the vehicle.
z
Lower the vehicle till the swing arm down to the
bottom and the lifting pads leave the vehicle chassis,
and then release the lowering handle.
z The swing arms under the vehicle must be fully
shrunk
Note: When the lift doesn’t work, you must
switch off the power.