25
Setting the language:
To change the language of the display, go to the Settings screens loop (see point 5.2), press Down until the
“press ENTER to change laguage” screen and press
Enter to access the language configuration screen.
From the new screen, press Enter to change the language and press Esc or let the timer run out to confirm
the new language.
Setting the Units of Measure (UoM):
To change the Units of Measure used by the controller, go to the Settings screens loop (see point 5.2), press
Down
until the “press ENTER to change
Units of Measure
” screen and press
Enter to access the Units of
Measure configuration screen.
From the new screen, press Up or Down to select the Units of Measure to be changed:
-
User interface: Changes the units of measure used by the display of the chiller, both the External
controller display and also the Webserver controller display.
-
Modbus TCP/IP: Changes the units of measure used to transmit data through the Modbus TCP/IP
communications.
-
Web pages: Changes the units of measure of the information shown on the Webserver.
Please note and bear in mind that a different set of Units of Measure can be selected for each of these three
options.
Press Enter to highlight the current Units of Measure, press Up or Down to change them and Enter again to
confirm the selection.
x3
x4