Lauda P 10, Руководство по эксплуатации

Страница: 80 / 160

5.11.2 Adjusting the volume of signal tones
The device indicates errors, alarms and warnings both visually and acousti-
cally.
In this menu, you can adjust the volume of the signal tones for: Errors, alarms
and warnings.
The volume settings are: off, low, medium and loud.
1.
Open the Home window.
2.
Touch the Settings

Basic settings

Signal tone tile.

A list of signal tones appears.
3. Touch an entry in the list.

The text turns white.
4. Move the slide switch to the right to increase the volume.

The setting is immediately active.
5. Touch the [<] button repeatedly until the home window appears.
5.11.3 Positioning tiles
This section is relevant for:

Device operation using the Command Touch unit
The 17 tiles in the home window can be sorted into any sequence. You can
the place the most frequently used tiles at the front positions.
1.
Open the Home window.
2.
Touch the Settings

Basic settings

Tiles configuration tile.

All tiles appear consecutively numbered in a list.
3. Touch the buttons for the tiles you wish to rearrange.
Symbols and captions are displayed on each of the buttons.
The number on the right of the button indicates its position in
the sequence.

An input window appears for manual entry.
4. Enter a new number.
5. Press the [OK] button to return to the previous screen with the new
setting configured.
6. Touch the [<] button repeatedly until the home window appears.

The tiles are sorted into the new sequence in the home window.
5.11.4 Operating mode following a power failure (auto start)
In general, the device is required to resume operation after a power failure.
However, you can introduce a manual activation step for safety reasons.
Fig. 45: Adjusting volume of signal tones
Fig. 46: Positioning tiles
V6 PRO bath thermostats and circulation thermostats 80 / 156