S1 Dream Espresso Machine – GUI Addendum
Dream GUI Addendum
Page 4
3
The Dream’s Machine Off and Turning On Screens
When the machine is Off and the Programmable
On/Off Timer is Disabled, you just see a blank, unlit
screen
When the machine is OFF and the Programmable
On/Off Timer is Enabled and On/Off times have been
set, the screen shows the next ON time.
When the machine is Off, you press and hold the
Power button until you see this screen for several
seconds, then you will see the Home Screen as
depicted in paragraph 3.
4
Steam Boiler Water Level Sensor Threshold Settings
If this is improperly set and you have very soft water, you could get a hot water overflow out of the
steam boiler.
The water level sensor on the first production run of Dreams was connected to the control board with
the leads reversed. This caused the signal to control board to be slightly off from what was expected
by the software resulting in overfilling the steam boiler. Rather than recall the first batch of machines
to swap the sensor leads, LaSpaziale put in a software work around. It is now possible to select one
of two thresholds depending on whether you have one of those original machines or a later machine.
These are referred to as Threshold A and Threshold B where Threshold A is what the setting is
supposed to be and Threshold B was added as the fix for the first batch of machines. Your machine
should already be set to the correct value which is Threshold B for the following ranges of serial
numbers and Threshold A for anything else:
Dream machine serial # 259451-259547
Dream T machine serial # 259487-259496
