Laski Predator, Руководство по эксплуатации

Страница: 44 / 59

Predátor P 56RX
44
- Insert 3 steel tubes in the space between the rollers and the track. Rotate the
driving gear in reverse so that the steel tubes proceed with the track and contact
the front idler wheel.
- Exercise force sideways to slide the track and lift it off the front idler wheel.
Installing the rubber track
- Make sure that you are always in safe conditions with the machine
lifted before performing this track installation operation.
-
Mesh the track links in the sprocket and place the other end of the
track on the front idler wheel.
- Rotate the driving gear in reverse slowly and push the track soles into the frame.
- Position the track using a steel tube and turn the driving gear again.
- Make sure the track links mesh correctly with the sprocket and with the front
idler wheel.
- Adjust track tension as set out previously. Replace the cover and lower the
machine back onto the ground.
Fig. 26 – Rubber track
The structure of the rubber track is shown above (fig.26). The steel cables and the
metal core are embedded in the rubber. The carved profiles function gives stability
on soft terrain. The wheel guides, located on the inside of the track, prevent the track
from sliding off the guide rollers.
Breakage of steel cables
Excess track tension can cause steel cables to break in the following
conditions:
-
when stones or foreign matter accumulate between the track and
the undercarriage frame;
- when the track slips off its guide system;
- in case of great friction such as rapid changes in direction.