Laski ATR 90, Руководство по эксплуатации, Страница: 8 / 29

TRENCHER
ATR 90
8

While taking the machine over from another person or always before work
make sure if all controls, guards and other safety elements are complete and
properly installed. They serve for your safety.
 Avoid wearing free parts, such as ties, scarves and shawls, belts etc. In case of
longer hairs use always a proper head piece. Otherwise, such a person is not
allowed to operate this machine.

While working, wear always personal protective equipment – protecting shield
or goggles, protective gloves, working shoes and working clothes properly
buttoned.

This manual describes also some common troubles and failures which could
occur and which are easy to be remedied by an instructed person. Other
problems and faults should be announced directly to the manufacturer, the
LASKI Service Centre that is always ready to help you.

Before any checks or servicing stop the engine, disconnect the spark plug
cable and wait until any motion stops.
 Do not put any objects or tools on the machine.

While displacing the machine on the plot the cutting chain bar must be set
horizontally and the machine operator should stand in the given attendant’s
place.
- The manufacturer does not bear responsibility for any damages or injures to
the third persons or to other equipment resulted from disobedience to
instructions given in this manual
- While handing the machine over to another person make sure if all controls,
guards and other safety elements are complete and fully functional.
- Do not remove guards and other safety elements. They serve for your safety.
- Keep the given intervals for checks of bolted joints. The first check should be
done after first three operating hours.
- Always after work clean all parts of the machine. For cleaning do not use fuel
or other oil products.
- At windy weather orientate the trencher in such direction to avoid exhaust
gases and dust bothering the operator. .
- Stop working if some parts running hot are covered with dust and soil
deposits. Clean such parts any time when required.
- Keep this machine beyond the reach of naked flames,
- Keep in mind all the parts and surfaces that may get hot from operation, i.e.
especially the engine, hydraulic elements, motion parts, bearings and exhaust
manifold parts.