Laski ATR 90, Руководство по эксплуатации, Страница: 17 / 29

TRENCHER
ATR 90
17
- Protect the product against oil products. Remove any spilled oil immediately
and wipe off all oily spots.
- Keep the stored machine beyond unauthorised person's reach.
- Do not let the chain bar sink on a hard base (concrete) – for underlaying use a
wooden board.
- Always put the machine aside on a flat and solid floor
- Do not put any objects or tools on the machine.
Checks before Operation
-
Before putting the trencher into operation check up the entire machine for
completeness.
- Check up all bolted joints, especially on the trenching chain.
- Check up all chain tips for completeness. If one of them is damaged, change it
immediately.
- Warning! Be always aware that the chain tips are fitted as left and right.
- Check up hydraulic hoses for wear and tightness. Replace them if necessary or
every four years at least.
- It is strictly forbidden to start working with removed guards.
- It is not allowed to carry out any modifications and technical changes on the
machine without prior permit by the manufacturer.
- It is not allowed to start machine with spilled oil on its parts.
- Before any adjustment put the machine out of operation, i.e. at idle state of the
chain and of the engine.
- Keep all unauthorised persons or animals out of range of the machine (20 m at
least) while working.
- While working, wear always personal protective equipment – protecting shield
or goggles, ear protection, protective gloves, steel toe protection boots and
working clothes properly buttoned.
Coupling to Carrier
The trencher should be coupled to a carrier that must be fitted with a corresponding
clamping plate.