Master-Slave Operation
This mode will allow you to link up to 32 units together without controller.
1. Voltage: AC110V or AC220V-240V/ 50HZ-60HZ/ Fuse: 2A/250V
1. Install the units in a suitable position (laying or appending).
2. Rated Power: 30W
2. Choose a unit to function as Master mode, set dipswitch to select Sound Active or
3. Laser: 25+25mW@532nm, green DPSS laser,100+100mW@650nm, red DPSS laser
AUTO mode. The others must be set to Slave mode, set dipswitch to select Slave mode.
4. Working Modes: DMX, Sound Active, AUTO, Master-Slave
3. Use standard XLR microphone cable chain your units together via the XLR connector
5. DMX Control Channel: 7 channels
on the rear of the units. For longer cable runs we suggest a terminator at the last fixture.
6. Graphics & Effects: more than 100 patterns, over 300 effects
4. Turn on the all units' power, the units begins reset, then the unit begins working. The
7. Interface: 3 pins XLR jack for DMX or Maser-Slave linking
slave units will react the same as the master unit.
8. Size: 600*180*150mm
5. The units will react to the low frequencies of music via the internal microphone. Adjust
9. Weight: 6.8Kg
the audio sensitivity knob on the back of the master unit to make the unit more or less se-
nsitive in sound active.The panel has LED indicating for sound active.
1. Various working modes
Includes four working modes as DMX, Sound Active, AUTO and Master-Slave Control
for different applications.
Universal DMX Operation (DMX mode)
2. Various programs
This mode allows you to use universal DMX-512 console to operate.
The double tunnel laser beam is compages, more than 50 laser patterns, over 200 laser
1. Install the units in a suitable position (laying or appending).
effects. Different working modes has different program.
2. Use standard XLR microphone cable chain your units together via the XLR connector
3. DMX control
on the rear of the units. For longer cable runs we suggest a terminator at the last fixture.
The unit has 7 channels to control in DMX mode. The unit has BLACK OUT function.
3. Assign a DMX address to each the unit using dipswitches, see the "DMX Address
The uint will shut OFF if no DMX512 signal.
Quick Reference Char".
4. Master-Slave function
4. Turn on the all units' power, the units begins reset, then the unit begins working.
The system allow link many units (as slave unit) together to doing synchro job without
5. Use DMX console to control your units.
console in sound active or AUTO mode.
5. LED indicating and shut-off function
In sound active mode, the unit's panel has LED indicating for sound active. The unit will
shut off after 8 seconds when the music stops.
6. DPSS Laser
Use Diode-Pumped Solid State green laser, stable output and long working life.
Page 2
Page 7
Technical Specification
Features
……
1: Master: Sound/AUTO
POWE
N
：
Slave
2
：
Slave
1: DMX Mode
N
：
DMX Mode
2
：
DMX Mode
……
POWE
DMX Signal
