laserglow.com/industrial
The projected line can be focused by rotating the small
red knob on the back of the fixture. Adjust until the line is
as thin as possible. There will only be one ideal focus
position.
5
X
✔
The projector does not have a power switch and it will turn
ON as soon as power is connected with the Relay box.
6
NOTE:
When installing the power supply, do not add cable extensions between the power supply and the light fixture.
The length of cable between the power supply and fixture should be as short as possible (6 feet maximum, 3 feet or less
recommended). Any extensions required to bring power to the projector should be added on the AC side of the power
supply.
MOUNTING RECOMMENDATION
To produce the clearest possible projection, it is recommended that the Virtualine™ LED SWITCH be mounted directly
above the center point of the projected line. Mounting the fixture near one end of the line will cause the far end of the line
to lose focus, which will cause it to appear wider with more blurry edges. Mounting the fixture off to one side of the line,
such as on a wall, will cause the line to appear wider and with more blurry edges, particularly the far edge. In many
environments it will not be possible for the fixture to be mounted directly above the center of the projection, for example
due to obstructions or other obstacles. If this is the case, it is recommended to mount the fixture as near as possible to the
ideal position to minimize distortion of the projected line.
It is normal for the ends of the line produced by the Virtualine™ LED SWITCH to fade out to nothing over a distance, and
for the middle of the line to be the brightest area.
✔
✔
✔
VirtuaLine™ SWITCH LED Line Projector
