,
Symptom
Cause
Remedy
~6.Player
stops
immediately
after
• Disc is loaded upside down (CD, CDV, one-sided
• Load the disc correctly
with
the label side
playback
started.
LD discs).
upward.
• The playing surface ofthe
disc is dirty.
• Use a soft cloth and lightly
wipe off the dirt
from
the surface
of the disc. If necessary,
moisten a cloth with diluted neutral detergent
to remove heavy dirt or fingerprints.
• Disc is not properly
set on the disc table.
• Set the disc properly.
7.No sound output.
• The stereo amplifier
is not correctly connected.
• Connect the amplifier
correctly .
• You are not operating
the stereo
amplifier
• Refer to the operating
instructions
for the
correctly.
amplifier,
and operate the amplifier
correctly.
• The connection term inals and/or the plugs ofthe
.Clean
the plugs and terminals
and connect
connection
cords are dirty.
again.
.The
plugs
of
the
connection
cords
are
• Make sure that connections are made correctly.
disconnected,
or are not fully pushed in.
• The player is in pause mode.
• Press PLAY •. and restore the player to play
mode.
S.Sound is distorted.
• The audio
output
jacks are connected
to the
• Connect to the AUX, CD, VDP, LD, or VCR jacks.
PHONO jacks.
• The connection terminals and/or the plugs ofthe
.Clean
the plugs and terminals
and connect
connection
cords are dirty.
again.
• The plugs of the connection
cords are not fully
• Push the plug in firmly.
pushed in.
When troubles
occur:
When some troubles
occur during use of the player, the following
display (service number) appears on the display of the player and theTV
screen. If you are in those trouble, follow the "Remedy"
below.
Displayed number
Condition
of the player
Remedy
U1
A disc is not loaded correctly on the disc table. Or,
Reload a disc corresponding
to a disc guide on
a disc is dirty.
the disc table.
Wipe the disc with a soft cloth.
U2
Open the disc table and press •. again.
FS
Two discs are loaded on the disc table. Or, a disc
Load only one disc on the disc table.
is dirty.
Wipe the disc with a soft cloth.
P2
(The displayed
number
after P, F, L, E differs
Open the disc table and press •. again.
l3
depending
on the condition
ofthe
player.)
If the same service
number
is displayed,
the
E4
player is in abnormal condition. When requesting
service, please notify the displayed
number on
the display ofthe player or on the TV screen (for
example, 'service number E 4').
HO
The player is in abnormal
condition.
When
requesting
service,
please
notify
the
H1
(The displayed
number after A differs depending
displayed number on the display of the player or
AS
on the condition
of the player.)
on the TV screen (for example, 'service number
H1').
28
<VRBl139>
En
