Symptom
Cause
Remedy
5. Disc is rotating
but there
is no
• The TV set is not turned
on.
.Turn
on TV.
picture.
• Wrong
connections
from player to TV.
• Make correct connections
.
6.
Picture
continuously
moves
• The TV vertical-hold
control
is not adjusted
.Adjust
vertical-hold
control
on TV.
vertically.
properly.
7.
Particular
disc does not
• The playing
surface of the disc is dirty.
• Use a soft cloth and lightly wipe off the dirt from
playback
properly.
The
the surface
of the disc. If necessary,
moisten
a
playback
stops
in the middle
cloth with
diluted
neutral
detergent
to remove
of the disc program.
heavy dirt or fingerprints.
• The disc is warped.
• Change the disc.
8.
Sound
is unnatural
or
• CX system is turned ON for disc which has no
.Press
AUDIO D/A to turn CX system
OFF.
distorted.
D~
mark.
9.
No sound
output
during
.MULTI-SPEED
or STILL/STEP
playback
is
• Press PLAY ~ to set the player to normal
play
playback.
being performed.
Sound is output only during
mode.
the normal
play mode. The audio signals are
not output
during
other playback
modes.
10.During
STILL playback,
a part
• Even ifthe disc is a standard
play disc, there may
of the screen
image
shakes.
be some cases in which a fully still image cannot
be obtained,
but this does not mean that the
player or the disc is defective .
11.CHAPTER
SKIP, CHAPTER
.Disc
in which
no chapter
numbers
are
• Press DISPLAY
to check if chapter
number
is
PROGRAM
PLAY and
recorded
is loaded.
displayed.
CHAPTER NUMBER
SEARCH
cannot
be performed.
12.Certain
discs take too long to
• It takes
time
to read the
recorded
code,
• Press CLEAR and picture will appear .
search
or are not searched.
depending
on the disc.
(At this point, a slightly
different
scene from that
which
has been searched
for may appear.)
13.Certain
discs take too long to
• There are errors when the disc code is read.
• Press.
and stop the playback. Press PLAY ~ and
start
or do not start.
(There is no damage to the unit.)
start the playback
again. (Repeat this operation
a few times.)
14.The player
takes too long to
.Same
as item 12
above.
.Same
as item 12
above.
find point
A-B (INTERVAL)
(The repeat mode is canceled.)
REPEAT operation.
15.Picture
other
than
instructed
is
• Method of inputting
numerals
in the TIME NUMBER SEARCH mode differs, depending
on whether
searched
in TIME NUMBER
time number
is recorded
on disc in hours and minutes
or minutes
and seconds as shown
below:
SEARCH mode.
[e.g.112-minute
search
• Disc in which time number
is recorded
in minutes.
ICHPfTM
I
U
I
PLAY
I
"minutes"
• Disc in which time number
is recorded
in minutes
and seconds.
I
CHPrrM
I
U
U
I
PLAY
I
"minutes"
"seconds"
27
<VRB1139
>
En
