LaserBit LB Series, Руководство пользователя

Страница: 46 / 69

LaserBit LB Series 4.3 page
46
Receiver Alignment
•
After a few seconds unplug the plugs of the motor controllers on both sides!
The motor control is a “light-buffer” this saves the power for the bad weather and in
the same time protects the receiver against overload. During the alignment it can be
used manually, to avoid the saturation, and keep the detector voltage on the level
where it can be still monitored. The detector voltage can be increased to seven volts;
above seven volts you won’t be able to monitor the detector voltage. This plate is
located in front of the receiver, and you can rotate it (clockwise decreases the
detector voltage, counter-clockwise increases).
•
Follow the steps below
1
Switch on one of your transmitter on one side, and switch off all the others.
Switch off the transmitters on the other side too.
Orders of the switches:
You can check which transmitter is in use, after you switched on one of the
switchers, with the green LED on the back of every transmitter. Each LEDs are
indicates if them transmitters are functioning, and transmitting.
2
Move the head with the off switched transmitters until you can get the
biggest incoming light efficiency on the other side.
3
Fix the head as hardly as you can!
4
Repeat this with the other head too.
The receiver alignment should be done on both sides; the requirement is some
incoming light from the remote side (at least receive). This alignment will determine
the position of the head and in the head the position of the receiver. The idea is
similar to the focusing, but the only way to find the focus is to move the head.
You can check the incoming light efficiency in two ways. Once you can use the
LEDs of the receiver. Second is to measure the detector voltage using the two pins
on the motherboard (if you have not got management in your head, then the
detector voltage is been measurable on the blue and the brown wires of the heads
own power cable too).
Because of the weight of the heads for the
vertical moving you can use the spacers as
it is shown on the figure. For this moving
you need two wrenches. With one of them
you have to hold the head of the bolt, and
with the other you can turn the thick nuts to
lift or loose the plate of the ABU.
To not enable any movement after the
receiver alignment on the vertical angle of
the head and due to the heat expansion
please close the locking nut under the thick
nut, as it shown on the figure, on both
sides.
Please note before the vertical receiver alignment we strongly suggest doing the
horizontal the same way as it is written above