LaserBit LB Series, Руководство пользователя

Страница: 53 / 69

LaserBit LB Series 4.3 page
53
•
Put the four M4,5x70 cross
headed self-tapping-screws
through the four free holes of
the metal plate
•
Pull up the four 6x15 spacers
(the shorter ones) to the screws
•
Tight the screws into the wall-
plugs, and tight it up as strong
as possible for the appropriate
fastening
S
S
t
t
r
r
u
u
c
c
t
t
u
u
r
r
e
e
o
o
f
f
t
t
h
h
e
e
g
g
r
r
o
o
m
m
m
m
e
e
t
t
s
s
Connecting the head to the ODIU, and the ODIU to the power
supply
Ensure that the cables are connected as it seen below.
For the power connection recommended to use
three-wired Ø0,75mm cables. The order of the
connection can be seen on the figure.
•
P – Phase
•
N - Neutral
The necessary power can be supported to the head by
the connector which can be seen in the figure next to this
text. Order of the cables from the head: (the four-twisted-
pair-wired cable)
•
Red - +12V
•
Black - GND
•
Green - -12V
10.4.3 Fixing the heads
Your
LB-5000
head can be fixed to its stand with
an Alignment Base Unit (ABU). On the figure you
can see an ABU, and a plinth of a
LB-5000
unit,
and the necessary fixing parts. The necessary
nuts and washers can be found on the legs of the
head. The steps of the fixing are:
•
First, fix the ABU to the stand using the
washers and nuts
•
Place the head to the ABU
•
Fix the bolts with the nuts, using the
washers
•
Tight up all the nuts.