LaserBit LB Series 4.3 page
37
Beam Alignment
•
Switch off all of the transmitters on both sides.
•
Switch on one of your transmitters on one side.
•
Move the beam to the middle of the remote head.
You can move the beam with the
screws on the back of the transmitters.
The directions of beam moving in the
function of the turning direction of the
screws can be seen on the figure.
You can check the position of the
beam using a digital camera with
infrared lenses. You can see the beam
shining on the landmarks around the
remote head from the side of the
transmitter, or until dusk you can see
the line of the beam with your own
eyes.
From the remote side you can see the
light of the beam behind the head with the shadow of the head on a surface (for
example on a wall), or if you see toward the side of the transmitter, there you can
see shining the beam on landmarks, and with the growing and declining of the
shining rounded plate, which is the beam, you can follow its moving.
•
Repeat the beam alignment with each transmitters on both sides
In every transmitter there are two shipping screws against the
bigger moving of the tube. These screws allow only less
movings for the transmitters, so if you need bigger moving you
have to pick them out first.
Anyway,
Laserbit
strongly recomends that you take all of
them out first…
Содержание LB Series
Страница 1: ...1500 2500 5000 Users Manual 4 3...