LaserBit Giga Series 4.3 page
24
9.2 Mounting brackets for GigaPINTOs
Laserbit
provides the following mounting bracket for
GigaPINTO
. A simple fixing
technique of this bracket can be seen on the following figure, required tools are as
follows:
- drilling
machine
- 10mm
wrench
Bracket assemblage
:
Using the provided
M8x20 bolts attach
thelegs to the
main mounting
Installation steps:
•
Place the bracket on the wall
•
Mark the wall with a permanent marker
•
Use your 12mm wall drill to drill all of the holes into the wall
•
Clean the holes
•
Place the wall-plugs into the holes (please note that some times you need to
use hammer to put the wall-plugs into the hole, if you have to please be
careful not to break the wall-plug
)
•
Place the bracket to the wall an line it up to the holes
•
Put the screws into the wall-plug through the hole on the leg of the bracket
(please see the figure above)
•
Tighten up the screws
