LaserBit Giga Series 4.3 page
30
Connecting the head to the ODIU, and the ODIU to the power
supply
Ensure that the cables are connected as it seen below.
For the power connection recommended to u
three-wired Ø0,75mm cables. The order of the
connection can be seen on the figure.
se
•
P – Phase
•
N - Neutral
The necessary power can be supported to the head by
the connector which can be seen in the figure next to
this text. Order of the cables from the head: (the four-
twisted-pair-wired cable)
•
Brown - +30V
•
Green - +8V
•
Twisted (orange-white & green-white) - GND
•
Orange - -8V
10.2.2
Fixing the heads
Your
GigaPICO
head can be fixed to its
stand with the three M6x25 bolts.
On the figure you can see a plinth of a
GigaPICO
unit, a head of a
GigaPICO
mounting bracket, and the necessary
fixing parts. The steps of the fixing are:
•
First place the head to the stand
•
Place the bolts into the holes which
is easily accessible for the
installation and the two cuts
•
Place up the washers and spring
washers
•
Fix the bolts with the nuts
After you put up the washers and the nuts, do not screw the nuts up tight because of
the comfortable positioning (see the chapter of Alignment).
After the fixing, place the two M6x90 tangent bolts into the two of the four holes on
the corners of the plinth. The important is that the bolts have to be in opposite
corners. You can do the vertical fine alignment with these bolts.
