L’ARTISTICO SRL |
21
Cod. 40297 | Rev. 09 | 05/2021 |
EN
4. REMOTE CONTROL INSTRUCTIONS
The remote control works up to a maximum distance of 7 meters (without obstacles) and allows you operating your pellet appliance.
› Button 1
- Navigation
For reducing temperature and power output and scrolling down worth the menu.
› Button 2
- Navigation
For increasing temperature and power output and scrolling up worth the menu.
› Button 3
- ON-OFF and BACK
Hold for 3 seconds for switching the appliance on and off. Press once for getting back into the menu till home
page.
› Button 4
- ROOM TEMPERATURE SETTING
Press for entering the room temperature setting menu with buttons 1 and 2.
› Button 5
- POER OUTPUT SETTING
Press for entering the power output level 1 to 5 setting menu with buttons 1 and 2.
› Button 6
( air equipment )
Key not operating
› Button 6
(hydro equipment)
-
Set WATER TEMPERATURE
Allows you to access the desired temperature by pressing buttons 1 and 2.
› Button 7
- MENU and OK
Press for entering the main menu than use buttons 1 and 2 for scrolling; press button 7 again for entering the
desired sub menu.
Press to confirm selection (OK).
DISPLAY SCREEN
AIR EQUIPMENT
HYDRO EQUIPMENT
In case no buttons are pressed for 30 seconds after switching on the appliance the remote control enters the stand-by status and the display goes
off. Press any button to reactivate.
The remote control is supplied with a wall rest.
Do not place the remote control near the appliance or close to other heat sources.
For best results we suggest to
locate it at a height of 150 centimeters. The maximum operating range of 8 meters from the appliance depends on architectonical barriers (walls).
The remote control should be handled with care and not exposed to the weather (sun, rain).
The control is fitted with AAA cells (included). Change batteries every year or when low. Remove the cover on the backside to access
the battery location. Please dispose flat batteries properly. If doubst check with your local re cycling center.
TOLERANCE INDICATOR OF TEMPERATURE ON THE REMOTE CONTROL is + or - 2° C
