background image

 IND-HVAC-DTW-UVC-R1-SS series

BREAKAGE

!

CAUTION

     

         Broken Quartz is

 SHARP

.

Wear protective gloves when handling broken ultraviolet lamp(s). In the event of breakage, 

DO NOT

 

use a household vacuum cleaner to pick up quartz fragments. Sweep up debris into a plastic bag and 

dispose of properly

.

DISPOSAL OF MERCURY ADDED LAMPS

Germicidal ultraviolet lamps, like standard fluorescent lamps contain small amounts of mercury. 

Mercury added lamps should not be placed in the trash. Dispose of properly. For further information 

regarding the disposal and recycling of lamps containing mercury, along with Federal and State 

requirements visit www.lamprecycle.org. 

TROUBLESHOOTING

Always disconnect power to the unit before performing any service or maintenance.

!

WARNING

Use personal protection equipment, such long sleeves with no gaps between cuffs and gloves, and 

ultraviolet resistant face shield, if troubleshooting Air Duct Disinfection Unit.

IMPORTANT:

 This unit is to be serviced 

ONLY

 by qualified, and appropriately trained and/or licensed personnel.

Table 1 – Troubleshooting

Problem

Possible Cause

Corrective Action

Unit not operating.

No electrical power.

Verify that the unit is connected to a live power 

source.

Power connection to fixture is loose 

or disconnected.

Verify power connection to fixture is 

fully engaged.

Germicidal lamp not operating.

Germicidal lamp(s) not properly 

seated.

Confirm connection between lamp and 

lampholder is tight, and that lamp that is 

making full contact with lampholder.

Germicidal lamp(s) faulty.

Swap suspect lamp with known good lamp. 

If known good lamp does not operate,

replace ballast.

Ballast not functioning.

Locate ballast and replace.

Lamp Operation Indicators 

(LEDs) not operating.

Germicidal lamp(s) out.

Check lamp(s) and replace.

!

Larson Electronics, LLC

 

 Phone: (800) 369-6671 

 Fax: (903) 498-3364 

 www.larsonelectronics.com 

9

 of 

10

 

THESE INSTRUCTIONS MAY  NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS. 

SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT 

[email protected]

 OR BY PHONE AT 1-800-369-6671 FOR FURTHER ASSISTANCE. 

PLEASE VISIT LARSONELECTRONICS.COM FOR 

WARRANTY

 AND 

RETURN

 INFORMATION.

Содержание IND-HVAC-DTW-UVC-R1-SS Series











Отзывы: