![background image](http://html1.mh-extra.com/html/larson-electronics/expcmr-ndaa-ip-poe-series/expcmr-ndaa-ip-poe-series_user-manual-and-quick-start-manual_3753412004.webp)
IP Camera Network Setup Guide
Larson Electronics, LLC
Phone: (877) 348-9680
Fax: (903) 498-3364
www.larsonelectronics.com
4 of 11
•
H.265+ / H.265 / H.264OVC / H.264 / MJPEG
compression
•
120 dB Wide Dynamic Range
•
Ultra low light sensor
•
120 ft Full Frame Illumination Smart IR array,
•
Supports onboard storage up to 128GB Max
microSD (card not included)
•
IP67 rated, −22 °F ~ 140 °F temperature range
•
ONVIF Profile S & Profile G, PSIA, CGI, ISAPI
WARNING
!
Failure of the power or Ethnernet connector due to
moisture or another contaiminant is considered an
installation error, which voids the waranty. If installing
this camera in a location such as an overhang, shop,
garage, kitchen, etc. where high humidity or dust is
present, seal these connections adequately.
CAUTION
Do not apply power to the camera at this time. Before
applying power to the camera, ensure that the polarity is
correct. An incorrect connection may cause a malfunction
and can damage the camera.
6.
Secure the camera to the mounting surface using appropriate
screws.
7.
Apply power to the camera through the 12Vdc power cable or
PoE switch/injector, as configured.
Camera drop cables
Installation
Before installation:
•
Make sure that the device is in good condition and all
the assembly parts are included.
•
Check the specification of the products for the
installation environment.
•
Make sure that the wall or ceiling is strong enough to
withstand 3 times the weight of the camera.
During installation:
•
Camera Lens
: Handle the camera carefully to prevent
scratching or soiling the lens. If the lens or IR array
shield becomes soiled, clean it only with approved
products. See the cleaning section.
Step 1. Mounting the camera
Typical ceiling mounting
1.
Mark the location of the screws that anchor the mounting base
to the mounting surface. See the note above. If you are
routing the drop cable through mounting surface, also mark
the position of the hole for the drop cable.
2.
Drill holes for the screws that anchor the base to the mounting
surface. The mounting hardware provided is appropriate for
most surfaces. However, depending on the surface materials,
more appropriate fasteners may be required.
3.
Drill a 3/4” hole through the mounting surface for the drop
cable, if necessary.
4.
Route extension cables from the power source and LAN
switch (or LAN with PoE) to the mounting location.
5.
Connect the network LAN and power extension cables to the
camera drop cables:
a.
Connect the Ethernet LAN cable to the camera LAN drop
cable. Protect the connection from moisture and other
contamination, if necessary. A Weatherproof Ethernet
Fitting is provided. Installation instructions for the fitting
are included later in this document.
b.
If the camera is not powered using PoE (Switch or
Injector), connect the 12 Vdc power cable to the camera
drop cable. The polarity of the drop cable is shown to the
left.
Lens
NPT Hub
Adjustable
mounting
bracket