44429367
Montageanleitung
Assembly instruction
Gültig ab/
valid from
08.03.2021
EPIC
®
LS1.5 Vierdorn Crimpzange
EPIC
®
LS1.5 4-indent crimping liers
Dokument/
document
: L44429367DE_EN
Version/
version
: 00
Seite 7 von 8
page 7 of 8
Wir behalten uns alle Rechte gemäß DIN ISO 16016 vor.
Calibrating the reference value
For preparation, the battery must be removed.
Open the pliers.
Turn the adjustment knob to the stop at the lower setting point (turn counter-clockwise; see figure) and leave it
there (figure 1).
Insert battery; "CAL" appears on the display to prompt you to calibrate (figure 2).
Adjust the pliers with the gauge (see also section "Calibrating the pliers") (figure 3).
Keep the "ON/OFF" button (1) pressed and press the "MODE" button (2) using the gauge. Keep both buttons
pressed for 5 to 7 seconds. Release the "MODE" button (2) after 5 seconds and then the "ON/OFF" button (1)
(figure 4).
The digital display automatically jumps to the gauge value 2.0 mm (figure 5).
The pliers are adjusted and ready for the crimping parameters to be set.
Troubleshooting
Displayed
Cause / Solution
E1
After changing the battery: Rotate the adjustment wheel to the lowest setting before inserting
the battery. Next, calibrate the pliers. See the section "Calibrating the reference value".
After approximately 50,000 ... 200,000 cycles: E1 sporadically appears on the display with the
crimping setting, to indicate the wear limit has been reached. If E1 continues to appear on the
display, despite carrying out calibration repeatedly, the pliers are worn and must be sent in for
service.
E2
There is excessive play between the punch and the internal cylindrical gauge.
Repeat the calibration.
Maintenance and repair
Unauthorized changes to or unintended use of the manual crimping pliers excludes the liability of the
manufacturer for any damage resulting from this. The manual crimping pliers must be clean and in good order
before starting work. Any residue from the crimping process must be removed from the crimping jaws and
locator. The joints must be lubricated regularly with a light machine oil and protected against dirt. Please ensure
that all bolts are secured with circlips.
Repairs to the 4-arbor crimping pliers may only be carried out by the manufacturer of the pliers.
