Manufacturer/Supplier
Product Type
RPM
Cycles Per
Tel No
Fax No
(01494) (01494)
883237
Model No/Nos
Serial No
Product Nett Weight
Recommended Use Of
Balancer Or Support
Recommended Hose Bore
Size - Minimum
Recommended Max.
Hose Length
Ins
M/M
Ft
M
Foreseen Use
This screwdriver is designed for the tightening and loosening
of threaded fasteners within the range as specified by the
manufacturer. It should only be used in conjunction with
1/4" male hex shank screwdriver bits and fastener drivers.
Do not use the tool for any other purpose than that specified
without consulting the manufacturer or his authorised
representative.
Putting Into Service
Air Supply
Use a clean lubricated air supply that will give a measured
air pressure at the tool of 90 p.s.i./6.3 bar when the tool
is running with the trigger fully depressed. Use recommended
hose size and length. It is recommended that the tool is
connected to the air supply as shown in figure 1. Do not
connect the tool to the air line system without incorporating
an easy to reach and operate air shut off valve. The air
supply should be lubricated. It is strongly recommended that
an air filter, regulator, lubricator (FRL) is used as shown in
Figure 1 as this will supply clean, lubricated air at the correct
pressure to the tool. Details of such equipment can be
obtained from your supplier. If such equipment is not used
then the tool should be lubricated by shutting off the air
supply to the tool, depressurising the line by pressing the
Work Stations
The tool should only be used as a hand held, hand operated
tool. It is always recommended that the tool is used when
standing on a solid floor. It can be used in other positions,
but before any such use the operator must be in a secure
position having a firm grip and footing. The operator must
adopt a firm grip sufficient to resist the torque reaction of
the tool, i.e. the tool will try
to turn in the hand. The
operator must also be aware
that when loosening fasteners,
the tool can move quite
quickly away from the fastener
being undone. An allowance
must be made for this rear-
ward movement to avoid hand
entrapment. The operator must
also make allowance that if
the tool does turn in the hand,
the hand is not trapped
against any rigid object.
No
Page No 1
Pistol Rev. Screwdriver
Adjustable Clutch
UT5964A
3/8
10
30
10
1,800
Includes - Foreseen Use, Work Stations, Putting Into Service,
Operating, Dismantling, Assembly and Safety Rules
Operator Instructions
Important
Read these instructions carefully before installing, operating,
servicing or repairing this tool. Keep these instructions in a
safe accessible place.
Universal Air Tool Company Limited
Unit 8
Lane End Industrial Park
High Wycombe
Bucks
HP14 3BY
lbs
Kg
2.2
1.00
Noise
Sound Pressure Level 84.3 dB(A)
Test Method Tested in accordance with
Pneurop test code PN8NTC1 and ISO
Sound Power Level 89.7 dB(A)
Vibration
Test Method Tested in accordance with ISO
standards 8662 Parts 1 & 7
Less than 2.5 Metres / Sec²
Air Pressure
Recommended Working
6.3
bar
90
PSI
Recommended Minimum
n/a
bar
n/a
PSI
Maximum
7.0
bar
100
PSI
Personal Safety Equipment
Use - Safety Glasses
Yes
Use - Safety Gloves
Use - Safety Boots
Use - Breathing Masks
Use - Ear Protectors
