3: Summary of CLI Commands
XPort Pro™ Command Reference
41
line level commands
Description
<line> = number of the line (serial port) to be
configured.
lpd <line>
Enters the configure lpd level.
<line> = number of the line (lpd serial port) to be
configured.
name <text>
Sets the name for this line.
no clear line counters
Restores the serial counters to the aggregate
values.
no command mode
Disables command mode for the current line.
no command mode cp
Disables control of a CP to enter command mode.
no command mode serial string
Prevents the user-defined serial boot string from
being used to enter command mode in the CLI.
no command mode signon
message
Clears the signon message displayed at boot time
and when entering command mode.
no gap timer
Removes the gap timer, so forwarding depends on
the line speed.
no name
Removes the name of this line.
parity even
Uses a parity bit on the line for even parity.
parity none
Does not use a parity bit on the line.
parity odd
Uses a parity bit on the line for odd parity.
ppp <line>
Enters the serial line PPP level.
protocol lpd
Applies Line Printer Daemon (LPD) protocol on the
line.
protocol lpd or tunnel
Applies LPD or tunnel protocol on the line.
protocol none
Uses no protocol on the line.
protocol ppp
Applies point-to-point protocol (PPP) on the line.
protocol tunnel
Applies tunnel protocol on the line.
reassert
Asserts line status with current configured values.
show
Displays the current status.
show command mode
Shows the command mode settings for the current
line.
show history
Displays the last 20 commands entered during the
current CLI session.
show line
Displays the current configuration.
show statistics
Shows the line statistics.
state disable
Disables the line so data cannot be sent/received.
state enable
Enables the line so data can be sent/received.
stop bits 1
Uses one stop bit after data on the line.
stop bits 2
Uses two stop bits after data on the line.
