Lantronix EDS2100, Руководство пользователя

Страница: 24 / 149

3: Installation of EDS1100
EDS1100/2100 Device Server User Guide 24
Figure 3-4 EDS1100 RS-485 (2-wire) Pinouts
Back Panel
On the EDS1100 back panel, there is a power plug, reset button, and an RJ45 (10/100) Ethernet
port as shown in
Figure 3-5 .
Figure 3-5 EDS1100 Back Panel
The Ethernet port has two LEDs that indicate the status of the connection.

Left LED
- Green ON 100Mbps Link
- Green Blink 100Mbps Activity
- Orange ON 10Mbps Link
- Orange Blink 10Mbps Activity

Right LED
- Green ON Full Duplex
- OFF Half Duplex
The Ethernet port can connect to an Ethernet (10 Mbps) or Fast Ethernet (100 Mbps) network.
Reset Button
You can reset the EDS1100 to factory defaults, including clearing the network settings. The IP
address, gateway, and netmask are set to 00s.
To reset the unit to factory defaults, perform the following steps.
1. Place the end of a paper clip or similar object into the reset opening (back panel) and press for
a minimum of 3 seconds.
2. Remove the paper clip to release the button. The firmware restores factory default settings to
the configuration and reboots the unit.