Lanner NCA-5520, Руководство пользователя

Страница: 25 / 123

25
Installing the CPU
Please note that the system delivered to you is already installed with the processor and that this processor,
LGA3647, comes with rather sophisticated design; therefore, the assembly of which must be handled with
exclusive tools and extreme care by professionals. It is strongly recommended that you not make any
adjustments to, remove or even re-install the processor on your own. If handling the processor on your
own is inevitable, please read through the instructions in this section and refer to the
official tutorial
released by Intel
®
to make sure you have acquired the necessary knowledge and comply with the
requirements.
Installing the processor onto the motherboard involves two stages:
1. Mount the processor onto the heat sink to make a PHM (Pro Heat Sink Module)
2. Install the PHM onto the motherboard.
Tools Required
Note : The images of tools shown in this document are merely for reference; the actual tools you
use might differ.
Parts Explanation:
Tool Description
Torque screwdriver
(Star T30)
Set to 1.36 N.m. or 12 in-lbf for tightening
the nuts which fasten the PHM on the
bolster plate.
ESD Protection
(ESD gloves, ESD-safe
work surface, etc.)
During the entire assembly process, at
least wear a pair of ESD gloves to avoid
damaging or contaminating the electronic
parts while enhancing your own safety.
Item Description
Processor
Please avoid touching the gold fingers or
package lands of the processor even if you are
wearing ESD gloves.