Assembly Instructions
LANIER R/C
MARINER
.120
LANIER R/C, INC.- P O Box 458 - Oakwood, GA 30566 - Ph 770-532-6401
!
Copyright 2002 Lanier R/C, Inc.
16
16. Drill three ¼” holes, as shown in the photo.
FUEL TANK ASSEMBLY
1. Locate the fuel tank and assemble the parts
on the stopper. Bend the vent line carefully to
avoid kinking. File all sharp corners on tubing
end so fuel line will not be cut. Make sure inside
of tank is clean before installing stopper on tank.
2. Wrap fuel tank with bubble wrap (not
supplied) to cushion it. Hold it in place with cello
tape. Do not use foam, it will absorb water.
3. Cut two lengths of medium fuel line 7” long.
Install them on the vent and supply tubes
coming from the tank. Slide the tank in place as
shown. Feed the lines through the two holes in
the firewall.
19, Install the throttle servo on the mounts in
the pod. It may be necessary to shim the servo
up so the pushrod will align better with the
throttle arm. Remove the servo output wheel
and assemble an EZ Connector on it. Cut a
small hole in the bottom of the pod, next to the
mast, to exit the throttle servo connector. Tape
the connector lead to the mast.
