Lang R60S, Установка, эксплуатация, обслуживание и устранение неисправностей, Страница: 12 / 24

Maintenance and Cleaning
12
Cleaning
WARNING
KEEP WATER AND SOLUTIONS OUT OF CONTROLS.
NEVER SPRAY OR HOSE CONTROL CONSOLE,
ELECTRICAL CONNECTIONS, ETC.
CAUTION
MOST CLEANERS ARE HARMFUL TO THE SKIN, EYES,
MUCOUS MEMBRANES AND CLOTHING. PRECAUTIONS
SHOULD BE TAKEN TO WEAR RUBBER GLOVES, GOGGLES
OR FACE SHIELD AND PROTECTIVE CLOTHING. CAREFULLY
READ THE WARNING AND FOLLOW THE DIRECTIONS ON
THE LABEL OF THE CLEANER TO BE USED.
The range should be thoroughly cleaned at least once a week in addition to the
normal daily cleaning to insure against the accumulation of foreign material. Keep
inside of oven and metal deck clean, particularly around door opening, door edges
and at bottom of door opening so that the door may close tightly.
NOTICE
Oven cleaner used should be marked: "safe on aluminum".
Keep drip pans under range top plates clean.
Keep hotplate and griddle surfaces clean.
Outside of range and top should be kept clean.
Electric equipment is inherently clean and sanitary,
but may become unsanitary if dirt is allowed to
accumulate on it. Take advantage of the clean,
sanitary features of electric equipment. Give it the
regular attention that it deserves, the same as any
other highly perfected machinery, to insure best
results and continued high operating efficiency.
CALIBRATION
Calibration Check
Place thermometer in the center of oven cavity.
Set thermostat to 350
°
F and place both 3-heat switches in the “HIGH” position.
Allow the oven to preheat for at least half an hour.
Note cycle on temperatures and cycle off temperatures for 3 cycles. (Red indicator
light indicates when oven is calling for heat)
After 3 cycles average the temperature. ( Add all six temperatures and divide by 6)
Calibration Adjustment
A 1/16” flat blade screwdriver with a 2” shaft is required to make adjustments on the
thermostat.
Maintain the oven temperature at 350
°
F.
Without turning the thermostat, remove the knob.
Locate the adjustment screw at the base of the shaft and insert the screwdriver.
Grasp the shaft and turn the screwdriver. Counter clockwise to increase and
clockwise to decrease (1/8 of a turn will move the temperature 5-7
°
F in either
direction).
Reinstall the oven knob and recheck the oven temperature.