Landoll BRILLION TURFMAKER II SL, Руководство оператора

Страница: 78 / 100

3-20 9K998
OPERATION
Seed Shaft Sensor Console with
Clutch Control - Optional
Basic Operation:
During normal operation the Console LED for the Seed
Shaft will not be illuminated. The Shaft Sensor will be
activated by the Magnet Wheel Assembly installed on the
Seed Shaft being monitored. The Shaft Sensor is a
standard Loup Shaft Sensor, set to 20 second delay
timing. When no signal is detected for 20 seconds by the
sensor, the LED in the Console will illuminate and the
audible alarm will sound indicating a fault. The alarm will
become silent after 30 seconds and will not sound again
until the Seed Shaft returns to a fully functional condition.
NOTE
If Shaft Sensor stall alarm occurs, be aware that the
seeder has not been planting for 20 seconds.
The Clutch Master toggle switch allows you to go from
“SEED” to “NO SEED” operations.
General Operation
1. The minimum horsepower requirements are typically
6-8 horsepower per foot. This will vary widely due to
speed, depth, moisture, and types of soils. Local
dealers can help in making recommendations for
your areas. For 3Pt Hitch models size tractor by 3Pt
Hitch Capacity.
2. Operating speed is typically 4.5-6 mph. Excessive
speed can result in undesirable germination, seeder
bouncing, or other unpredictable results. Reduce
speed in rocky conditions to prevent wheel breakage.
Transporting the Seeder
1. Check and follow all federal, state, and local
requirements before transporting the Seeder.
2. The Seeder should be transported only by tractor
required for field operation. The implement weight
should not exceed more than 1.5 times the tractor
weight. Maximum transport speed for the Seeder is
20 mph for the implement.

CAUTION
3. When towing equipment in combination, the
maximum equipment ground speed shall be limited
to the lowest specified ground speed of any of the
towed implements.
4. Maximum transport speed shall be the lesser of
travel speed specified in the operator's manual,
speed identification symbol, information sign of
towed equipment, or limit of road conditions.
5. Slow down when driving on rough roads. Reduce
speed when turning, or on curves and slopes to
avoid tipping. Equipment altered other than the place
of manufacture may reduce the maximum transport
speed. Additional weight, added tanks, harrowing
attachments, etc. may reduce implement load
carrying capabilities.
6. Before transporting:
• Know the height and width of the implement being
towed. Markers, tanks, attachments, etc. can
increase the height and width of the implement.

DANGER
• Check to see that the tractor hitch capacity is rated to
carry the Laden Mass of the Seeder.
• Use provided pins that properly fits the Lift Arms or
Quick Hitch and Implement Hitch.
• Plug in the safety lights to the tractor 7 Pin
Connector.
• Fully raise the Seeder Hydraulic Lift and 3Pt Hitch.
• Make sure all Transport Locks and Hair Pin Cotters
and Clevis Pins are installed. (See “Transport Lock
Engaged” on page 3-5.)
Excessive speed may result in loss of control of
the tractor and implement, reduced braking
ability, or failure of the implement tire or
structure. Do not exceed the implement
maximum specified ground speed regardless of
the capability of the maximum tractor speed.
Stay away from power lines when transporting,
extending implement. Electrocution can occur
without direct contact.