Landoll 7833, Руководство оператора

Страница: 23 / 38

OPERATION AND MAINTENANCE
4-7
TABLE OF CONTENTS
1. When adjusting the rear disc gangs laterally, it is best
to set the center gang first and then sequentially set
the rear gangs on the wing assemblies secondarily.
2. When adjusting the center section rear gang
assembly, it may be necessary to first adjust the wing
gang assembly in the direction the adjustment is
being made.
3. While the typical row unit spacing is 10”, the spacing
between the row units at the fold break is
approximately 10-3/8”.
• Once the center section rear gang assembly is
adjusted and secured in place, the wing rear
gang assemblies should be set relative to the
center section rear gang assembly.
4. The wing rear gang assemblies should be adjusted
so the first row unit adjacent to the nearest center
section rear row unit is 10-3/8” on center from it.
See
Figure 4-4
W
Figure 4-3: Lateral Adjustment of Gang Assemblies (1 of 2)
W
Figure 4-4: Lateral Adjustment of Gang Assemblies (2 of 2)
Vertical Shank Adjustment Hybrid Shank Adjustment Compound Shank Adjustment
10”
14”
10”
10-3/8”
10-3/8”
Default Front
Hinge Gap
Default Front
Hinge Gap
Typical Row Spacing
10”
10-3/8”
Rear Hinge Gap
10-3/8”
Rear Hinge Gap