3-2
F-894-0919
ASSEMBLY INSTRUCTIONS
Figure 3-2: Tire and Wheel Installation
Unfolding the HSL
WARNING
1.
Tip the top of the center section reward far enough to
lift the wing frames several inches above the wing
rest saddles located on the hitch. The center section
is tilted backward by extending the large cylinder
located over the hitch (circuit with red hose wrap.)
CAUTION
2.
With the wing frames just above the wing rest
saddles, open the wing assemblies up far enough so
that when lowered, they will clear the wing frame
rests located on the hitch. The wing assemblies are
opened (un-folded) by extending the wing fold
cylinders (circuit with yellow hose wrap.)
8
AND 10 STUD HUBS
Applles to M22 X 1.5 studs/two piece flange nut.
All threads are right hand metric.
First Tighten Flange Nuts to 50ft. lb. Using
sequence shown.
Check Disc-Wheel for proper
positioning on pads and proper seating
against flange.
Then Tighten Flange Nuts to recommended
torque using sequence shown.
3-573-010210
RECOMMENDED TORQUE: 450-500FT. LBS.
8
4
6
2
3
7
5
1
7
5
3
10
8
6
4
9
2
1
DANGER
Read and Understand the installation, service and safety instructions manual before installing or
servicing the hub. Failure to do so may result in personal injury or death, and may result in a
compromise of your vehicle’s safety through loss or failure of a wheel or compromise of the braking
system.
Use a torque wrench to assure proper torque, failure to do so will compromise your products service,
life and safety. Under torque and over torque can cause thread and/or nut damage, and may result in
the loss of a wheel.
Recheck torque after the first 50 to 100 miles of service. Parts may seat naturally, causing the torque
to drop. Proper torque is essential for the service, life and safety of this product.
DECAL - 3-573-010210
Always unfold the 7833 on a level surface and
away from overhead power lines. Keep
bystanders and pets clear of the area.
Do not lift the wing assemblies more than a few
inches above the wing rest saddles when the
wing assemblies are folded forward.
