1
Introduction
The Rehabilitation Treadmill was developed to meet the changing needs of rehabilitation and therapeutic centers. It is not
intended for use in “pay-for-membership” facilities such as health clubs, gyms, YMCA’s, etc.
INSTRUCTION MANUAL
Be sure to familiarize yourself with this manual. Look it over carefully. Be sure you understand the control panel operation
before using the treadmill.
WARRANTY INFORMATION
Fill out your warranty registration card and mail it in today. Landice backs your treadmill with a strong warranty.
For the factory to respond to any problems you may have, we need your warranty information on file. Do it today.
Landice will send you a complimentary Landice T-shirt upon receipt of your warranty registration card.
SELECTING A LOCATION
Install your treadmill in a climate controlled room.
Allow a minimum clearance of
18 inches on each side
of the treadmill.
Allow a minimum clearance of
4 feet at the rear
of the treadmill.
Failure to leave ample clearance at the rear of the treadmill could result in the user becoming trapped between the treadmill
and the wall should the user accidentally trip and fall while exercising.
Be sure the line cord has plenty of slack and does not get pinched underneath the treadmill when the treadmill elevates up
and down. Make sure the treadmill is plugged into a dedicated line.
BEFORE YOU BEGIN
These are some things you should do before you start to exercise on your treadmill:
• On L7 treadmills it is necessary
to remove the bolts which hold
the treadmill to the pallet.
• Start by removing the top bolts.
• Lay the treadmill on the ground,
and then remove the bottom
bolts by placing the treadmill on
your toolbox.
• With the bolts removed, the
treadmill will be free to move
around in the box.
• Remove the metal strapping
around the box.
• Using a razor blade knife, cut the
box just above the bottom row
of brass staples along all sides
of the box.
•
DO NOT cut through the
center of the box, as you could
damage the treadmill.
• Remove the box and discard.
• The treadmill components
are held together with plastic
strapping.
• Carefully cut and remove the
strapping. Remove the treadmill
upright and accessory boxes
from the treadmill. Lift the
treadmill off the pallet.
• Carefully remove the upright
side cover from the upright
assembly.
STEP 1:
Unbolt treadmill from pallet
STEP 2:
Cut the box off the pallet
STEP 3:
Unstrap the treadmill
Assembly Instructions
Landice_RTM_Manual_8.2011.qxd:Landice CT Manual-2/05 10/11/11 10:04 AM Page 7
