Upright Bike Assembly
32
11. Position seat cushion onto seat flange, then re-install
hardware (Figure 3-7) using a 13mm open end wrench
from the hardware kit. Fully tighten hardware.
Figure 3-7. Seat Bottom Installation
12. Prior to use, verify there is no remaining hardware in the
hardware kit and that all hardware is properly tightened.
13. If the bike is positioned on an unlevel surface, adjust each
foot pedestal using a 5/8 inch open end or adjustable
wrench (not provided).
14. Your upright bike is now ready for use.
Seat Flange
#13 flat washer
#13 Nylock nut
(3x)
