11
Detergents And General
Operating Tec
hniques
WARNING: Some detergents may
be harmful if inhaled or ingested,
causing severe nausea, fainting or
poisoning. The harmful elements
may cause property damage or
severe injury.
AVERTISSEMENT: Certains
détergents peuvent être dangereux
s'ils sont inhalés ou ingérés,
provoquant de fortes nausées, des
évanouissements et l'empoisonnement. Les
éléments dangereux peuvent causer des dommages
à la propriété ou des blessures graves.
STEP 1:
Use detergent designed
specifically for pressure washers.
Household detergents could damage
the pump. Prepare detergent solution
as required by the manufacturer. Fill a
container with pressure washer deter-
gent. Place the filter end of detergent
suction tube into the detergent
container.
STEP 2:
Apply safety latch to spray
gun trigger. Turn variable pressure
control handle counter clockwise to
low pressure.
NOTE: Detergent cannot be
applied using the Yellow nozzle.
STEP 3:
With the engine running, pull trigger to operate
machine. Liquid detergent is drawn into the machine and
mixed with water. Apply detergent to work area. Do not
allow detergent to dry on surface.
IMPORTANT: You must flush the detergent injection
system after each use by placing the suction tube
into a bucket of clean water, then run the pressure
washer in low pressure for 1-2 minutes
.
Thermal Pump Protection
If you run your pressure washer for 2 minutes without
pressing the trigger on the spray gun, circulating water in
the pump can reach high temperatures. When the water
reaches this temperature, the pump protector engages
and cools the pump by discharging the warm water onto
the ground. This thermal device prevents internal
damage to the pump.
Cleaning Tips
Pre-rinse cleaning surface with fresh water. Place
detergent suction tube directly into cleaning solution and
apply to surface at low pressure (for best results, limit
your work area to sections approximately 6’ square and
always apply detergent from bottom to top). Allow
detergent to remain on surface 1-3 minutes. Do not allow
detergent to dry on surface. If surface appears to be
drying, simply wet down surface with fresh water. If
needed, use brush to remove stubborn dirt. Rinse at high
pressure from top to bottom in an even sweeping motion
keeping the spray nozzle approximately 1’ from cleaning
surface. Use overlapping strokes as you clean and rinse
any surface. For best surface cleaning action spray at a
slight angle.
Recommendations:
•
Before cleaning any surface, an inconspicuous
area should be cleaned to test spray pattern and
distance for maximum cleaning results.
•
If painted surfaces are peeling or chipping, use
extreme caution as pressure washer may
remove the loose paint from the surface.
•
Keep the spray nozzle a safe distance from the
surface you plan to clean. High pressure wash a
small area, then check the surface for damage. If
no damage is found, continue to pressure
washing.
CAUTION - Never use:
•
Bleach, chlorine or other corrosive chemicals
•
Liquids containing solvents (i.e., paint thinner,
gasoline, oils)
•
Tri-sodium phosphate products
•
Ammonia products or acid-based products
ATTENTION: Ne jamais utiliser :
•
Eau de Javel, produits à base de chlore et
autres produits chimiques corrosifs
•
Liquides contenant des solvants (c.-à-d. diluant
à peinture, essence, huiles, etc.)
•
Produits à base de tripolyphosphate de sodium
•
Ammoniac ou produits à base d'acide
These chemicals will harm the machine and will damage
the surface being cleaned.
Landa SEA MS Operator’s Manual 9.801-720.0 - AJ
Содержание SEA 2.8/1000
Страница 2: ...2 Landa SEA MS Operator s Manual 9 801 720 0 AJ...
Страница 16: ......