Land Pride RC4614, Руководство оператора

Страница: 35 / 66

Section 2: Adjustments
Table of Contents
7/30/20 RC4614 & RCM4614 Rotary Cutters 331-937M
31
Center Deck Leveling (Rear of Cutter Shown)
Figure 2-2
Center Deck Leveling (Front of Cutter Shown)
Figure 2-3
39119
39117
Leveling Wing Deck
Figure 2-4
Wing Deck Leveling
Refer to Figure 2-4:
The wing section will need adjusting if its top is not level
with top of center deck when wing is unfolded.
1. With tractor hydraulics, raise the wing fully up
2. Shut tractor down properly before dismounting. Refer
to
“Tractor Shutdown Procedure”
on page 15.
3. Remove transport locks (#3) from transport position
to field position as shown. Be sure to secure
transport locks to storage bracket (#2) with hairpin
cotters (#1). See
“Transport Lock”
on page 36 for
detailed instructions.
4. Lower wing to ground position and pull cutter straight
forward six to ten feet to allow outer wing wheels to
properly align themselves.
5. With tractor hydraulics, fully extend all three
rephasing cylinders and then lower cutter to
approximate cutting height.
6. Check wing top to see if it is level with top of center
deck. If outer edge of wing is higher or lower than the
center deck, then the wing should be leveled as
follows:
a.
If the outer wing edge is higher
than the center
deck, loosen adjusting nut (#5) to lower the outer
wing edge until wing is level. Tighten adjusting
nut (#4) to the correct torque when level.
b.
If the outer wing edge is lower
than the center
deck, loosen adjusting nut (#4) several turns and
tighten adjusting nut (#5) until wing is level.
Tighten adjusting nut (#4) to the correct torque
when level.
39121
IMPORTANT: Make sure wing lift cylinder mount has
been relocated for field use. See
“Relocate Wing
Lift Cylinder Mount” on page 22.